Incorrect representation of Flexible duct in Single-Line promoted view.
Product(s):
OpenBuildings Designer
Version(s):
CONNECT Edition
Area:
Mechanical Design
Subarea:
Duct
Problem description Observing disconnection of Diffusor from Flexible Duct while promoting Seed.
Solution…
How to connect two vertically placed ducts
Product(s):
AECOsim Building Designer
Version(s):
08.11.09.866, 10.03.00.40
Area:
HVAC Design
Subarea:
Ducts
Problem Description
Proper connection is not occurring while joining two vertically placed…
Duct Sizing - Excessive Ductwork pressure due to Universal tees
Product(s):
Hevacomp
Version(s):
V8i
Environment:
N/A
Area:
Netsys
Subarea:
Ductwork
Problem
Excessive pressure drops found upon sizing ductwork system.
Solution
Hevacomp will often automatically…
Placing Flex Duct Around An Obstruction
Product(s):
AECOsim Building Designer
Version(s):
08.11.09.829
Environment:
N\A
Area:
HVAC Design
Subarea:
Ducts
Problem Description
How can I place a flex duct around an obstruction…
Elements are not visible
Product(s):
AECOsim Building Designer
Version(s):
08.11.09.831
Environment:
N\A
Area:
HVAC Design
Subarea:
Ducts
Problem Description
After the installation of AECOsim Building Designer the…
Duct sizing - Roughness figures
Product(s):
Hevacomp Mechanical Designer
Version(s):
V8i
Environment:
N/A
Area:
Netsys Ductwork
Subarea:
N/A
Overview
Roughness values used in Netsys Duct sizing calculations are dependant…
RE: "please change the working units to imperial units"
We seem to have the triforma config, but it does look like it is metric as per the image...
We get the warning at start-up and when we try to use the mechanical elements.
We don't get any warning for placing smart lines etc.
Turning off Centerlines in Round Ducts
Product(s):
OpenBuildings Designer
Version(s):
Connect Edition
Area:
HVAC Design
Problem Description
Can centerline display in the 3D model be turned off in a round duct?
Steps to Resolve
All round ducts automatically…