• What is the slot width of a Slot Inlet?

    Jesse Dringoli
    Jesse Dringoli
    Product(s): FlowMaster, StormCAD, SewerGEMS, CivilStorm Version(s): CONNECT Edition, V8i Area: Modeling Problem For a Slot Inlet, where do I enter the sloth width and how is it used? How do I solve for slot width for…
    • 7 months ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Wiki
  • How do catalog inlets handle clogging at low depths?

    Larry Abla
    Larry Abla
    Product(s): FlowMaster, StormCAD Version(s): CONNECT Edition, V8i Area: Installation Problem How do FlowMaster and StormCAD handle clogging at low depths, for an equal-length (curb opening length equals grate length) combination…
    • 7 months ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Wiki
  • Procedure for finding the curb length needed to capture 100% of gutter flow in a curb inlet with a continuously depressed gutter with no clogging

    Larry Abla
    Larry Abla
    Applies To Product(s): StormCAD, FlowMaster Version(s): 08.11.XX.XX Area: Calculations Original Author: Mark Pachlhofer, Bentley Technical Support Group Background This article focuses on how…
    • 10 months ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Wiki
  • Comparison of Inlet Performance between FlowMaster and GEOPAK Drainage

    AGranquist
    AGranquist
    As a double-check of GEOPAK Drainage inlet calcs I have modeled the same inlets in FlowMaster. Unfortunately, I am not getting the same results and I can't pin point why? I can provide some screen shots if necessary. Also, should I post this in the Road…
    • over 11 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum