Tentative Vertical Alignment and Cross Sections
Dear All
I have thee doubts in BRT.
1. I am importing survey data and creating surface. and I am creating a Horizontal alignment. My doubt is I need a Tentative Vertical based on the ground
surface. is it possible or not.
2. I have a Cross…
Cross Section Annotation For Every 5m or 10 m or for a Paticular Distance
Dear All
Thankfull for Responding my Questons I Have a Another Doubt and Problem,
i am Creating cross sections in BRT it is coming good, When I am Annotating the Cross sections the offset and eelevations are showing at ground change points only…
ASCII Profile Annotation Elevations Not Showing
Dear All,
I am Creating a Profile By Using the ASCII file with .se file, when annotating this file Only Station showing in the Drawong Elevation Not Showing,
What is the Problem, any other procedure is therre to shwon station elevation both in profile…
PROFILE RAIL ELEVATION
Dear All,
I am facing a problem with rail elevation this is most importent for me to show rail elevation in the profile, our railways did'nt accept with out rail elevations,
for rail elevation again i am going to auto cad.
I am creating a horizontal…
InRoad XM alignment without surface
Just started using InRoad XM. I was required to come up with vertical elevation of a portion of train track. I have graphically imported the horizontal alignment (2D) and I've imported the survey text data of the verticall alignment. No available surface…
Re: InRoad XM alignment without surface
The horizontal alignment received is 2D drawing with labellings of stations and curves and spirals. The vertical is based on part of the said horizontal alignment. Received was survey data in .XLS format.
I import drawing for the horizontal geometry…
Sewer Plan and Profile from GIS data - ArcMap .shp shape file
I have the following data in ESRI shap file (.shp, .dbf)
pipe data with up node, down node, up invert, down invert, diameter, shape
man hole data with lid elevation, bottom invert and shaft diameter
Can anyone help me with the steps to…
MX - Formula used to apply levels in Design Option 132
I need to provide a client with the formula used to apply levels using cubic reverse crossfall. (Design minor option 132). I remember that the formula was in the early versions of the MOSS manual but cannot find any reference to it in any MX help files…