The following describes the changes made in MOSES Version 7.00.
New Graphical User Interface
A new Graphical User Interface is now available. At this time, this interface is designed to render GL graphics, and to retrieve and display information from…
The following describes the changes made in MOSES Version 7.01.
General Changes
Users can now specify a thickness with #TUBE and the options -TOT_WEIGHT and -MULT_WEIGHT. Thus these load attributes can contribute weight.
Two new values -MAX_PERCENT…
The following describes the changes made in MOSES Version 7.02.
General Changes
The report given with the PLATE STRESS command in the structural post-processing menu has been changed to also report the principle stresses and the angle of S1 from…
The following describes the changes made in MOSES Version 7.03.
General Changes
In the past, error, warnings, etc. were written to the "OUT" file if they occurred during an INMODEL. This has been changed so that they will be written to the log file…
The following describes the changes made in MOSES Version 7.04.
General Changes
Emitting Models has been changed so that if the TITLE and SUBTITLE are not blank then they will be included as comments in the emitted file. Also, these commands honor…
The following describes the changes made in MOSES Version 7.05.
Miscellaneous Changes
The method of defining a roller class has been changed. Users can now specify a stiffness for a roller. Users should note that pipe assemblies will no longer work…
The following describes the changes made in MOSES Version 7.06.
Miscellaneous Changes
By default connectors are rendered as lines even when solid rendering is specified. This is because connectors are long and slender and may not show in the picture…