I am trying to apply an end condition exception to a template that has a right outside edge of pavement that is controlled by a horizontal feature constraint so the outside edge of pavement is able to vary (for example, at a turn lane taper transition…

In the old geopak the shape superelvation was used to crate plateau intersection. In SS4 is the recommended practice the same? Also if there is a model with a super elevation section can this be modified (extended or shrink) to make room for the plateau…

In a FDOT modified template the pgl right is plotting correctly but the PGL left has a constant error and when it get to the super elevation section it gets worst. Those anybody know why the cause PSL_1.LT_PVT_EOP_IN is not fallowing the PGL_LT.PGL…

once the super elevation has been added to the model I needed to and pgl left and right. I use the example from chapter 6 Exercise 6.5 using point controls, then I get this error " see below" .

Hello, I'm having issues dropping a barrier wall on my template design. I can't constrain the left bottom point (TP) because it gives me an error, see attached image. Any suggestions on how to drop the barrier wall on the template and how to constrain…