sabbir ahmed -static - 07.05.22.std SOMEONE PLEASE REPLY, Calculation sheet is not available as design has failed, why it is showing ?
sabbir ahmed -static - 07.05.22_foundation.xml
this is the code
STAAD SPACE START JOB INFORMATION ENGINEER DATE 09-Apr-22 END JOB INFORMATION INPUT WIDTH 79 UNIT METER KN JOINT COORDINATES 1 0 0 0; 2 0 12.085 0; 3 -1.05865e-015 0 5.763; 5 -2.11729e-015 0 11.526; 7 -3.17594e-015 0 17.289; 8 -3…
Hi,
I have created a section with section wizard by using plate elements in section builder as attached. i have exported to staad.pro with Prismatic option. Its not getting design with the Euro code and it showing the warning message as
*DESIGN NOT…
Hola tengo este problema en mi computadora, al asignar cargas muertas a mi edificio se producen estas áreas fuera del modelo que no me dejan trabajar, he buscado ayuda pero nadie me da una respuesta, aparentemente solo sucede en mi computadora por que…
Sir I have modelled and applied the loads in the staad interface the loads are applying but after the analysis in the output I'm getting warning that no member is loaded for the floor load generation! I have thoroughly checked the duplicate nodes,orphan…
Hi.
I recently got access to the student license of STAAD Pro. It was working well until last few days. The application is not starting. Below given screen appears and then there is no further movement in the loading. I tried re-installing the application…
Upto STAAD.Pro ( CE V22 Update 5 )
Revision History Column is very impressive in terms of categories.
But in CE V22 Update 7 (current release) and CE V22 Update 6 is replaced by
Can we make the 'Available' and 'Selected' columns under the Load Cases tab searchable? Like when you're clicked into one of them and start typing a number, it'll jump to that Load Case? I have a few STAAD Models with moving loads, which generate several…
May you add an option for choosing the strength stirrups in RCDC,by default is 250 but when i want to use stirrup of 410 its not possible to change its strength in RCDC
Hello,
I had a question regarding this simple circular tunnel model shown below.
I have the following modeled to check the shear SQY. I know I'm missing something simple here so I hope I can get some help.
L=100 ft (total longitudinal length)…
Kindly add user interface offset tool in staad for look like a below link video
https://www.linkedin.com/feed/update/urn:li:activity:6739773333832912897/
Hello Everyone
For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…
Hello Everyone.
I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?
Dear sir,
I am doing the analysis of cable but the reactions are coming with an extreme value like 66kn along x. There is no any weight on the cable only self-weight is considered. Kindly explain to me why reactions are so conservative.
Also, guide…