20. Time History Results on symmetric model does not match when using AutoPIPE, why?
Applies To
Product(s):
AutoPIPE
Version(s):
ALL;
Area:
Report
Date Logged & Current Version
Feb 2020 12.02.00.14
Problem:
Per the given symmetric model (attached, original and one I created from scratch):
…
21. Calculate SAM and Expansion stress values independently, and then add these two stress values together in a single combination using AutoPIPE
Applies To
Product(s):
AutoPIPE
Version(s):
ALL;
Area:
Date Logged & Current Version
Jan 2020 12.02.00.14
Problem:
Calculate SAM stress values and Expansion stress values independently, and then add these two…
20. How are the moment results for the selected Combination Method (ex. SRSS, ABS, etc..) calculated in AutoPIPE?
Applies To
Product(s):
AutoPIPE
Version(s):
ALL;
Area:
Date Logged & Current Version
Nov 2019 12.02.00.14
Problem:
How are the moments in the Code Compliance report calculated based on different combination…
08. What is more important, AutoPIPE's results for Operating Conditions (ex. GrT1P1, GrT2P2, ...etc. ) or the individual load cases (ex. P2, T1, T2, Gr, P1...) results?
Answer:
The user would be advised to only look at the results for Operating Conditions (ex. GrT1P1, GrT2P2, ...etc). Would suggest that user turn off all non-operating conditions.
Example:
Give the following Analysis sets:
This would produce…
03. Why no Max Range combination was displayed for HDPE piping?
Applies To
Product(s):
AutoPIPE
Version(s):
ALL;
Area:
Results
Date Logged & Current Version
April 2019 12.00.00.14
Problem:
Why is there no Max Range code combination for HDPE piping with the "Include Max Range…
02. What value should be entered into the "No. of thermal ranges" setting in AutoPIPE?
Applies To
Product(s):
AutoPIPE
Version(s):
ALL;
Area:
Settings
Original Author:
Bentley Technical Support Group
Date Logged & Current Version
Jan. 2017 10.01.00.09
Problem:
What value should be entered…
08. The AutoPIPE code combination value of "Max Range {TR]" does not match the indicated combination value or any of the other Expansion combination values, why?
Applies To
Product(s):
AutoPIPE
Version(s):
All
Area:
Report
Original Author:
Bentley Technical Support Group
Date Logged & Current Version
July 2015 09.06.02.06
Problem:
The AutoPIPE…
05. Why does the floating dialog not show all the load cases analyzed in an AutoPIPE model?
Applies To
Product(s):
AutoPIPE
Version(s):
ALL;
Environment:
N/A
Area:
Results
Original Author:
Bentley Technical Support Group
Date Logged & Current Version
July. 2017 11.00.00.22
Problem:
…
04. How to get stress results for gravity load-case only in AutoPIPE?
Applies To
Product(s):
AutoPIPE
Version(s):
All
Environment:
N/A
Area:
Reports
Original Author:
Bentley Technical Support Group
Date Logged & Current Version
Jan 2015…
12. How to limit AutoPIPE's Output results to selected combinations?
Applies To
Product(s):
AutoPIPE
Version(s):
2004, XM, V8i, CONNECT;
Area:
Report
Original Author:
Bentley Technical Support Group
Date Logged & Current Version
May. 2016 10.01.00.09
…