Hi Richard,
Please create Service Request and attach relevant files like an intermediate file, Report.def file to investigate the issue.
-Regards | Rahul Kumar
Hello Richard,
Use below wiki article for reference.
http://communities.bentley.com/products/plant/design___engineering/w/plant_design_and_engineering__wiki/26531.grouping-of-supports-based-on-common-ec-class-name
Also check other related wiki for…
Good Day,
The isometric generated by OpenPlant Isometrics manager, has the wrong distance number on the dimension.
Here are the correct dimensions on the model:
But in the generated Isometric, you can see that the dimension to the support reads…
Hi,
I'm using OPIM .87 with AutoPLANT .235
When a tee support is included in an ismetric OPIM takes foever to run in fact I had to kill it because I didn't see the end. If the selection doesn't include the tee shoe it runs fine.
Any hint on this…