• Component not connecting/ Floating Component

    Melanie Galand
    Melanie Galand
    Anyone know what would cause this component to become unattached? The template doesn't show this, but when generating dynamic sections as well as actual sections it is just floating there.
    • over 1 year ago
    • OpenRoads | OpenSite
    • OpenRoads | OpenSite Forum
  • How to create a Toe Line of Embankment

    Naveen Verma
    Naveen Verma
    Hello, After Creating Template when i run the Roadway Designer, getting too many feature lines and want to show the Ditch / Fill (Intersect with Surface) above surface as Toe Line. My Template has 2 Conditions and Components Have 2 Conditions…
    • over 7 years ago
    • OpenRail
    • OpenRail Forum
  • Formula on a trigger line

    devildog
    devildog
    Can you use a formula to give a trigger line an option for instance if the distance between LT_SW_BACK_TOP_out and Rightof WayLine (Existing) is less the 0.25’ then draw a slope 1:3 from the back of sidewalk to existing Ground?
    • over 7 years ago
    • FDOT CADD Support
    • FDOT CADD Support - GEOPAK - Corridor Modeling
  • Cross section labeling - Geopak SS3

    Philip Mashuda
    Philip Mashuda
    I need guideance on cross section labeling. I have an “X” that shows on my Geopak SS3 cross sections. When I annotate the sections, I do not want to annotate slope to that point. How do I remove the “x” and not annotate the slope? Where is…
    • Answered
    • Anno_Prob.jpg
    • View
    • Hide
    • over 9 years ago
    • OpenRoads | OpenSite
    • OpenRoads | OpenSite Forum
  • Create Templates from DTM in InRoads

    Nthwrd
    Nthwrd
    I apologize ahead of time for my poor description of what I am about to ask... Is there a way in InRoads to take an exsisting DTM surface and create a template from it? We have a ditch running paralell to our road and are needing survey layout at 50…
    • over 13 years ago
    • OpenRoads | OpenSite
    • OpenRoads | OpenSite Forum
  • Cross Section: proposed surface/end condition doesn't intercept existing ground

    tktylin
    tktylin
    I am using Inroads Suite XM Edition. When I create my cross sections I notice that my proposed surface, in many cases, does not actually meet the existing ground surface like it should. In roadway modeler, the section views all look correct, but in the…
    • over 12 years ago
    • OpenRoads | OpenSite
    • OpenRoads | OpenSite Forum