Good morning / evening / afternoon all,
I was wondering if there was a way to have a template target a surface twice when creating a component.
I have a project where we're filling in part of a ditch between two embankments, but there's a…
I have a corridor template that has both variable fill sections and variable cut sections. The fill works just fine, but the cut does not work fully. When I test the template, it appears to be working, but does not fully display on the cross section explorer…
Hello,
After Creating Template when i run the Roadway Designer, getting too many feature lines and want to show the Ditch / Fill (Intersect with Surface) above surface as Toe Line.
My Template has 2 Conditions and Components
Have 2 Conditions…
I have set up a template for a driveway on a corridor I am working on. The corridor itself has ditches on both sides, and ties to existing terrain.
I am looking for the best option when it comes to tieing the end conditions of the driveway into the…
I have an end condition that I am attempting to have seek a feature XYZ. However, over a particular station range, the feature loops back on itself providing two solutions. Is there a way to have the end condition solve for on over the other without breaking…
Perhaps I am trying to use the wrong tool to do this, but I am having an issue trying to get my side slopes to draw correctly. I have a diamond interchange and I am currently modeling the ramps. I have a corridor "complete" for the mailine and the existing…
I'm having an issue with EC Rounding. The attached Pdf explains my problem. The blue line represents a normal EC without rounding, defined at a given slope (Say 25%). When I add rounding, the result I get looks something like the Red line. This isn't…