• Corridor Templates - Automatic update of constraints

    Catherine Shillito-Fox
    Catherine Shillito-Fox
    I have this template and would like the point BallastBtm to automatically move horizontally based on the relationships between other points in the template, specifically to find the lowest point from SB1 TO SB8 and move horizontally to x point = 0 (e…
    • 2 months ago
    • OpenRail
    • OpenRail Forum
  • Issues with Tunnel Templates | Closest ComponentConstraint | Tunnel Component rendering

    Arnab Dutta
    Arnab Dutta
    Hi guys, I'm currently working with this template, observe the selected Line component, it has two ends right and left as marked below. Issue #1 My goal is to project the line ends to the tunnel inner ring. The level of this line will vary depending…
    • 7 months ago
    • OpenRail
    • OpenRail Forum
  • Templates - Establishing relationship in Tunnel Templates

    Arnab Dutta
    Arnab Dutta
    Hi folks, I'm trying to establish a relationship between Two Points and one component. My goal is whenever " Single_Track_LR " go up or down, " SC_Left_Edge " point should also go up or down vertically but get attached to " Tunnel_Inner_Face " component…
    • Answered
    • 7 months ago
    • OpenRail
    • OpenRail Forum
  • Transitions between templates

    Andrzej Modrzyk
    Andrzej Modrzyk
    Hello, Is it possible to create transition between templates properly, when I use point control in my corridor (in templates, which are before and behind my planned transition)? As example I tried to make a correct transition using Single track - ballasted…
    • Answered
    • over 1 year ago
    • OpenRail
    • OpenRail Forum
  • Adding template by template drop doesn't work.

    Sebastian SARNECKI
    Sebastian SARNECKI
    Hello, I've started to work with OpenRail. Previously I was working with BRT SS2. I have an issue with adding templates to my corridor. I have horizontal and vertical alignment, corridor added. Previously I've opened template library. When I want…
    • over 2 years ago
    • OpenRail
    • OpenRail Forum
  • Circles in Section (ORLD)

    Can KABADAYI
    Can KABADAYI
    Hi Everyone, I hope You are doing well, and still healthy. About my question, I made a template for tram bridge, and there are cable pipes in the concrete. So I made it circle on template but on 3d view it shows the circles like triangulation…
    • Answered
    • over 3 years ago
    • OpenRail
    • OpenRail Forum