• Converting a PRV PSV or FCV to a Throttle Control Valve (TCV) in HAMMER

    Jesse Dringoli
    Jesse Dringoli
    Applies To Product(s): HAMMER Version(s): V8i, CONNECT Edition Area: Modeling Original Author: Scott Kampa, Bentley Technical Support Group Overview This TechNote will describe steps to model…
    • over 5 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Wiki
  • Modeling Valve closure in Hammer

    suminda
    suminda
    Hi, I am modeling a HDPE treated water pumping main to see the effects of a pump trip and a valve closure (at the end). I am planning on using a altitue valve and it is supposed to close when the tank is full and also another motor operated valve to…
    • over 11 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • Re: Modeling Backflow in TCV and FCV

    Jesse Dringoli
    Jesse Dringoli
    I assume you're using Bentley HAMMER. When you use a TCV or FCV, a discharge coefficient is calculated based on the head loss through the valve in the initial conditions. This discharge coefficient can be seen in the results section of the valve…
    • over 13 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum