• Converting a PRV PSV or FCV to a Throttle Control Valve (TCV) in HAMMER

    Jesse Dringoli
    Jesse Dringoli
    Applies To Product(s): HAMMER Version(s): V8i, CONNECT Edition Area: Modeling Original Author: Scott Kampa, Bentley Technical Support Group Overview This TechNote will describe steps to model…
    • over 5 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Wiki
  • Valve Closure example

    Jesse Dringoli
    Jesse Dringoli
    This example model illustrates different ways to model valve closure with a TCV. Advanced TCV closure modeling is not included. Note: This model can be opened in HAMMER version 08.11.00.30 and above.
    • TCV_Closure_Example.zip
    • over 14 years ago
    • Bentley Files
    • TSGWaterWasteWater
  • Modeling Reference - Valve Closure

    Luca Santos Billis
    Luca Santos Billis
    Applies To Product(s): HAMMER, WaterGEMS, WaterCAD Version(s): V8i, CONNECT Edition Area: Modeling Original Author: Jesse Dringoli, Bentley Technical Support Group Overview This technote explains…
    • 3 months ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Wiki
  • Modeling pump startup against a closed valve in HAMMER

    LWillnow
    LWillnow
    We are trying to model a pump startup scenario in HAMMER (v 8.11.03.17) with the pump starting 10 seconds into the simulation and the discharge valve starting to open up 15 seconds into the simulation. We followed the Tech Note for startup scenario but…
    • over 11 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • Modeling Valve closure in Hammer

    suminda
    suminda
    Hi, I am modeling a HDPE treated water pumping main to see the effects of a pump trip and a valve closure (at the end). I am planning on using a altitue valve and it is supposed to close when the tank is full and also another motor operated valve to…
    • over 11 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • Control valve response to transient event

    LWillnow
    LWillnow
    Is there a way to model the response of a control valve to a transient event beyond manually inputting the transient operational pattern? An example would be what happens to a PSV when the transient pressure drops below the pressure set point.
    • over 12 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum