• I am getting much greater headloss through a GPV with using the 2.2.0 engine than with previous versions.
    Craig S
    Below is the headloss through a GPV with a headloss curve for a backflow preventer using the 2.00.12 engine When the only change is switching to the 2.2.0 engine, this is the result. Is there some...
  • Utilizing more than one CPU/core in model calculation (multi-threading)
    Jesse Dringoli
    Applies To Product(s): HAMMER, WaterGEMS, WaterCAD, SewerGEMS, SewerCAD, StormCAD, CivilStorm, PondPack Version(s): 08.11.XX.XX and higher Area: Modeling ...
  • Adjusting Demands to Match Tank Level
    Staci Hartz
    Hi, I am modeling a water system that has three (3) tanks: 0.50 MG elevated tank (Tank 1), 0.50 MG standpipe tank (Tank 2), and a 0.75 MG composite elevated tank (Tank 3). Tank 2 and 3 are located next...
  • When I put tank at the end to fill it in 24 hours or 2 days, I always get the negative pressure at the Junction just before the tank, no matter how much head I put at the pump, the junction always shows...
    Noman Ali
    When I put tank at the end to fill it in 24 hours or 2 days, I always get the negative pressure at the Junction just before the tank, no matter how much head i put at the pump, the junction always shows...
  • Flowmaster Freezes When Printing or with Detailed Report
    Trevor Hughes
    Hello. The Flowmaster Bently program freezes and becomes unresponsive everytime the detailed report, print preview, print or print setup is selected. I have tried restarting the computer several times...