Changes to the SBEM calculation were recently introduced, mainly to incorporate new constructions from the updated NCM modelling guides. Thus, Energy Performance certificates and Compliance documents must now be generated with:
SBEM 5.3.a - for Part L 2…
Allows Hevacomp users - via an accredited Energy Assessor scheme provider - to work towards Energy Assessor status to show competency in production of EPC's using an approved SBEM interface…
Applies To
Product(s):
Hevacomp Mechanical Designer
Version(s):
V8i
Environment:
N/A
Area:
N/A
Subarea:
N/A
Original Author:
Bentley Technical Support Group
Hevacomp Update 4 is now available…
We are pleased to announce that the following ranges are now available for use in your Hevacomp calculations:
Hager devices “H3 Range MCCBs”
Hager boards
Quinn Radiator ranges
To avail of these you will need to install Hevacomp Content Pack…
As you may have noticed, the SAP calculation is no longer available in the latest version of Hevacomp. While SAP 2005 was available in Hevacomp v25, this is not available in Hevacomp v26 as the standards are no longer applicable.
It was not possible for…
Bentley Hevacomp are pleased to announce the release of Content Pack 1 for Hevacomp v26.
Upon the release of version 26.06 the Hevacomp installation came in two parts - the program installer and the content installer. This was so our Content Department…
Bentley Hevacomp are pleased to announce that Service Pack Update 3 is now available for download. Instructions on how to download and install this can be found here.
Update 3 incorporates important changes in Hevacomp Connect in accordance with BS 7671…
<Update>
We are pleased to announce that SBEM v5.2.g has been fully accredited for use in Hevacomp Update 4, available for download as detailed here.
<Update>
The Scottish building regulations are due to be updated from Section 6 2010 to…
