• RE: Assistance with tangent curves

    Ron Jones
    Ron Jones
    FYI: The point of tangency between the two arcs will always fall upon the line connecting the segments, even if the arcs have differing radii.
    • over 5 years ago
    • MicroStation
    • MicroStation Forum
  • RE: Assistance with tangent curves

    Ron Jones
    Ron Jones
    Hi David, Try this: Place a third line connect the two segments. Use the Place Arc (Start, End, Mid) With Tangent Point snap mode, snap to the end of the first line to define the start of the first arc. With Mid Point snap mode, snap to the…
    • over 5 years ago
    • MicroStation
    • MicroStation Forum