• RE: Pump Set to Off But is Adding Energy to the System

    Jesse Dringoli
    Jesse Dringoli
    Jose, thanks for sending the model. The flow into T-1 comes from two paths, one has 103 gpm and the other has 51 gpm. The pipe supplying 103 gpm can be traced back to two sources: T-CASAMERO and RES-1 (and PMP-NEW_WELL which is on). The pipe supplying…
    • 11 months ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • RE: Tanks Emptying and Won't Refill

    Jesse Dringoli
    Jesse Dringoli
    Thanks for sending the model. It appears that there is a very high headloss through PRV "COP-PRV-4" causing the HGL to be very low on the upstream side of your pump, which causes it to be unable to turn on (pass any flow) because the downstream HGL ends…
    • over 1 year ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • RE: Applying Extreme Flow Factors to Base Flows in SewerGEMS

    Sushma Choure
    Sushma Choure
    Hello Jose, SewerCAD (GVF-Convex solver), extreme flow factors can only be applied to unit loads. However there is workaround after loadbuilder run to convert base loads to unit loads and then you can use extreme flow factors. Please see below wiki…
    • over 3 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • RE: error message 51007

    Tom Walski
    Tom Walski
    Jose, A good place to start is View > Network Navigator > Network trace. Pick one of the queries like Find Downstream or Fidn Disconnected and you should be able to locate your problem area.
    • over 3 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • RE: How to manually make changes to assign Property Connection laterals after using LoadBuilder?

    Yashodhan Joshi
    Yashodhan Joshi
    Hello Jose, See my responses below; Jose Ortiz said: Ok, so lets assume I change the referenced link to the correct conduit, will the Base Flow associated with each Property Connection be applied to the referenced link? Yes. Jose Ortiz said: It…
    • over 3 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum