Thank you, Vinay and Dilip Matange [Bentley] . The issue was addressed. The following file was replaced: C:\ProgramData\Bentley\LEAP Bridge Concrete OBD 10.10\Lib\default.lbclib

Hi Ivana, I sent you the answer throughout the SR 7001506504, Minimum reinforcement in "RobuSup". The formulation used by the software is the one written in RM Bridge Robustness Check document that I attached too. Any other question RM Bridge related…

Hi Kamel, If alignment and profile are correctly defined, try to extend the support lines for getting intersections at the extreme points. Many times due to the skew, the support lines need to be extended. You can also send us the file for further investigations…

Hi Tom, OpenTunnel supports multiple types of geometries and is not tied to a specific standard. OTD is a physical modeler, a BIM software that can produce the 3d model of the tunnel. When creating the analytical model for PLAXIS, the user can accommodate…

Hi, according to EC2 the following should be considered: The shear longitudinal reinforcement type will have the area value obtained from this calculation and the longitudinal reinforcement type will get the total area value, considering bending too…

Hi, 1. Export to IFC directly from OpenTunnel is not supported in the current version. An export from ifc can be done from iTwin i.e. send OpenTunnel to iTwin and from there export to ifc. 2. Customized attributes will be able to be defined automatically…

LandXML is a schema that is an industry standard that has been around for a little over 20 years now. Any civil engineering product should give you the ability to import and export this format. As Vlad points out, we can import LandXML, along with some…

Hi, Your xml file does not follow the rules that civil needs in order to correctly create the geometry. Please have a look at this information Import Geometry (bentley.com)

I would recommend you define the alignment using tangents and curves, not as a series of points from the XYZ data. Here is a link to the OpenRoads wiki page complete with a Learning path for ORD Geometry, along with links to many videos detailing how…

Hi Cris, This also causes some grief for us. We put support lines at every sharp edge and it creates a pizza of deck solids. We then unite them at the end using the solid tools. Messy but works. Really hope the point control functionality gets…

Hi Kamel, Thanks for the files. One solution can be to generate one second axis throughout the bridge structure, due to the wide eccentricity of the road alignment. After send this model to RM Bridge: Due to the high skew angles, it may be necessary…

You should be able to use the custom reinforcing tools for the deck reinforcement. For decks, I typically use the extract edge tool to get my guidelines or starter rebar shapes.

Hi, The "Slab Reinforcing" tool doesn't work for decks that follow curved alignments. Is this your case?

Thanks Ana for your prompt response. I have generated a service request for the issue. I found out that the error is only with files on ProjectWise, if I work on local drive, I am able to place the custom abutment/bent with no issues. Using the same…