This is a bug that still exists in 2020 R2. Try making your Template Drop start/end just before the limits of the Alignment to resolve the unclipped section.

Hi Signe, I have just found in 2020 R1 that if you reference your 2D model of the Geometry into it's 3D model and annotate the Alignment (in the 3D model), all alignment annotation will be created with the correct 3D alignment elevations. This may…

感谢您发现这个方法。我看该方法是位于PolyfaceVisitor类下的，该类的特点是每次返回一个值，再次调用能返回下一个。您依靠这个思路测试一下。请将测试结果在此反馈。 许多人都在找CE下用C#如何求一条射线和Mesh的交点，一直都没有找到。如何这个方法可以，记您一大功！

Hi Şükrü, Şükrü Baykan said: I am new in programming for Microstation/openroads. Please follow programming forum best practices and alwyas exactly specify what version (build number) do you use. There have been many versions of MicroStation and ORD…

This dialog can be found at Drainage and Utilities>Tools>Project Tools>Catchment Delineation Settings.

Post your question to the FDOT CADD support forum. https://communities.bentley.com/communities/user_communities/fdot_cadd_support/f/ There is a specific way to create a workset and setup the FDOTConnect install. Regarding your question, you can also add…

The recording on the Bentley server appears to be corrupted. It becomes garbled then goes completely blank after just a few minutes into the course. Is it possible to replace the recording? If not can the session be re-recorded?

Try this link: https://learn.bentley.com/app/VideoPlayer/LinkToIndividualCourse?LearningPathID=112219&CourseId=130194&MediaID=5019163

Although the recording is on the Bentley server it is hosed when you get a couple of minutes into it. I wonder if Bentley can replace it with a new recording.

I have been told that this dialog will be in the 2019 Release 3 version of OpenRoads Designer.

Hi Soren, The new software downloads site still needs a lot of work in my opinion - try the old one here: https://select.bentley.com/FulfillmentCenter/ Regarding expected release date for 2019 R3, I have the same question (and to finally get a…

Warren, This functionality was actually made available in ORD 2019 R1 and beyond. When you run the OpenRoads Modeling > Home > Model Analysis and Reporting > Civil Analysis > Create Cut Fill Volumes tool you are given the option to check "Compute…

An interior boundary must include proper elevations. I would recommend draping it on the surface before adding it as an interior boundary. Or add it to the surface as set to Exclude from Triangulation, Assign it elevations from the surface and then change…

Hi Gilles, The ability to drop a text field to normal text is finally now available in MicroStation CE Update 13 (using the drop tool) and I expect that this will be used as the Base for ORD 2019 Release 3. You should be able to do this shortly.

The only way at the moment is to remove all the annotation from all the models in the current DGN, then delete the Annotation Group and Annotation Definitions. It will then read the dgnlib. (You may need to stop ORD and reopen so that the updated dgnlib…