• Suggested Answer

    Export superstructure loads from Leap Bridge Steel to substructure design/analysis? 0

    1965 views
    19 replies
    Latest 5 days ago
     by Josh Revell
  • Suggested Answer

    column design in leap 0

    498 views
    10 replies
    Latest 5 days ago
     by Vinay mysore
  • Suggested Answer

    Bar Development Error for Calculating Flexural Capacity 0

    361 views
    6 replies
    Latest 6 days ago
     by William Shekarchi
  • Suggested Answer

    Question on "Width of all Compressive Struts" of "Hammer STM" +2

    5924 views
    23 replies
    Latest 6 days ago
     by Vinay mysore
  • Suggested Answer

    LEAP Bridge Concrete: Prestressed Box Beam End Block 0

    291 views
    5 replies
    Latest 13 days ago
     by Vinay mysore
  • Suggested Answer

    OpenBridge LEAP Bridge Concrete Substructure module EH Cap/Stem Loads 0

    265 views
    3 replies
    Latest 20 days ago
     by Vinay mysore
  • Suggested Answer

    LBC - Pile Bent Battered piles capabilities 0

    208 views
    1 reply
    Latest 20 days ago
     by Vinay mysore
  • Suggested Answer

    CT Loads on Footings 0

    225 views
    1 reply
    Latest 21 days ago
     by Vinay mysore
  • Suggested Answer

    LEAP Bridge Concrete Analysis/Design parameter, Cover 0

    203 views
    1 reply
    Latest 21 days ago
     by Vinay mysore
  • Suggested Answer

    Overstress factors not applied to column in LEAP Concrete? 0

    230 views
    1 reply
    Latest 1 month ago
     by Vinay mysore
  • Suggested Answer

    Girders not displaying in OBM 0

    278 views
    1 reply
    Latest 1 month ago
     by Vinay mysore
  • Suggested Answer

    LFR Rating in LEAP Steel +2

    1318 views
    12 replies
    Latest 1 month ago
     by Devon Kinsman
  • Suggested Answer

    Leap bridge concrete Flexure check 0

    354 views
    4 replies
    Latest 1 month ago
     by Vinay mysore
  • Suggested Answer

    LEAP Substructure - Full height abutment on piles - footing reinforcement design 0

    287 views
    1 reply
    Latest 1 month ago
     by Vinay mysore
  • Suggested Answer

    I am designing a footing cap for drilled shaft using STM model as per AASHTO but getting error message for Tension ties in Z direction. it doesn't help if i provide hook or exra reinforcement. 0

    316 views
    2 replies
    Latest 1 month ago
     by Vinay mysore
>