Hi, I am using STAAD.Pro CONNECT Edition V22. The concrete structure was original modelled in revit 2018 and transferred to Staad through ISM. When the solver is run, I receive a error message ' ***ERROR*** WRONG STRENGTH PARAMETER PROVIDED'. Attached…

I am new to STAAD pro connect. I need some help on how to model a steel transition cap shown in the attached photo. The cap consists of two top and bottom plates separated by cylindrical section. There are 24 gussets attached to the outer perimeter of…

I am new in Staad pro so please answer this question in very easy language....! What is the use of Foundation support i staad pro.... can we use this instead of fixed support... what is logic behind that support....

I am designing a roof structure which is about to be supported by a mezzanine platform. The whole platform is supported on a anchor rod at different locations It will be like, there are anchor rods at several locations on the mezzanine beam, which is…

Hi all, I am doing a composite beam design right now. STAAD has some specific function to simulate the composite beam section. But when we do the 3D analysis design, if we put the concrete plate on the floor steel beam directly, should we still use…