Dummy beam
Hello Everyone.
I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?
How can we consider Secondary beam moment behavior while rebar detailing without intermediate supports but connected between many primary beams
Hello,
I have few queries related to community hall without internal columns, my attached staad file
1. Main beam is of 17.27m length with size 450X725mm. This continuous beam is shown as passed even though L/d ratio is not meeting however it is satisfying…
minimum 13 stations are required for beam
when i open mdb file of etabs 16 and designing beam its shows "minimum 13 stations are required for beam" what is the meaning of this?