Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

Hello Everyone How can I reduce the development length bars in the beam (Figure 1-1), I'm running to get a result like this beam (figure 2-1) Figure 1-1 Figure 2-1

Dear sir, After design structure some beams & columns are not shown design. kindly help me with issue . PLEASE CHECK ATTACHED TEST MODEL. also give procedure for Dynamic design in Staad. Thanks. 2772.test model.STD

when i open mdb file of etabs 16 and designing beam its shows "minimum 13 stations are required for beam" what is the meaning of this?

Hello , I have done analysis and tried RC designer . the columns are safe. Beam summary show fails. please help me into this . cross section of beam is large i assume. 8284.COLLEGE PROKECT.STD

Dear sir, I want to camber a steel beam . I am putting the value 750 (length/offset =30000mm/40mm(we need to camber it 40 mm)) and respect value 1.6 but results are still same with deflection 50mm .Why deflection is not decreasing? Kindly also guide…