Hi, Can u explain anyone What is the meaning of REFORM 1 KGEOM 1 in non linear cable analysis what if i keep 0 instead of 1 " REFORM 1 KGEOM 0" Thanks in advance

Hello Everyone ! I Have Done Analysis For Window Model Using Prismatic General Section. But While Generating Report , No Property Values i.e. Ixx, Iyy, Izz For Prismatic Section Were Displayed in Utilization Ratio Table. Please Suggest How to get…

PDF Dear communities, Please provide me the solution or method to design & analysis the STEPPED column. For the reference, I have attached the pdf file, please check it & provide me the solution. Thank you.

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

How to rectify this failure known as 'Detailing failure' in RCDC

What is the easiest and accurate way to modeling complex and huge Concrete building projects, Including irregular elements and the shear wall? Can I model staad building planner?

Hello, I wanted an excel VBA programme by which i can get the plate corner moments/stresses for a particular group of plates. If anyone could share an excel with VBA code then it will be helpful as it saves lot of time.

warehouse.zip wind calculation also in that folder.... try to fix this probem guys

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?

Hello Everyone! In the attached Staad file, I am having trouble getting rid of few warnings. Also, I believe Wind loading is also not applied correctly. I used Staad V8i. Please help me. Regards, Pawan Waghmare

Hello to all, In reality horizontal braces (or vertical brace, beam, etc) that is design for tension only resist "some" axial compression capacity. Is there a way that this axial compression capacity can be input in STAAD? For example, a horizontal…

I think staad foundation advance still needs to be improved. Here are some suggestions. 1- When we import load cases and combinations from staad, we have to change description of every load and load cases by selection each one by one (i.e it is primary…