RAM Connection Gusset CBB NaN error
Hi Everyone.
I am trying to solve the connection between beam, column flange and gusset.
And i get the "Not a number" error. When i look at the result i find that the problem is in the Gusset forces:
In the "Loads" section i can see the forces…
Can´t assign Gusset CBB Connection
Hola a todos!
Estoy tratando de diseñar una conexion entre una columna y un gusset. Y no logro asignarla. Obtengo el siguiente mensaje:
Tengo gussets en ambas direcciones. Sé que no se puede resolver esto en una conexion unica, pero tampoco logro…
RAM Connection: Error in Gusset
I am modeling a CBB connection with a right beam/upper right brace configuration into the web of a column. I have created a custom column shape to mimic the use of a doubler plate at the column web. So far I have a W14x99 1_2 & W14x99 5_8 "doubled" web…
RE: RAM Connection Gusset Plate design issue
I take it the gusset plate frames into the column web here. If so, then it's the Nmin dimension that is coming out larger. It's using
Nmin = drigid + 2/*3 ,
where drigid is affected by the LH (length over plate) dimension of the gusset. I can get…
RE: RAM Connection Standalone - Column-Beam-Brace Connection - Assign Single Plate connections from the Design\Assign tab
Regretfully, this is a program defect that was introduced in version 11.0. The problem and a recommended work around are discussed on the web page below:
http://communities.bentley.com/products/structural/structural_analysis___design/w/structural_analysis_and_design__wiki…