Hi! The STAAD Editor of my model contains "STAAD.Pro Generated Comment" and below it is the previous node coordinates of node number 121 from my first revision of the model. The Analysis Output also contains the same comment. Where did the "STAAD.Pro…

Hello. Please go through attached PowerPoint and then the below discussion will make more sense. I am using STAAD version 20.07.11.70. The main problem is: when modelling decks or bulkheads which include offset beam elements and plates attached to…

Hello, I would like to model the same stack shown in fig and check it for wind and seismic loadings. Can you please guide me through step by step procedure to do so? Ravikant

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

Hello, I am currently working on a building slab, I have modeled it with two different methods, one with all beams and plates objects and another with only beams using floor load command. The Y total loads are very similar, I assumed it as equals, but…

How Can I change the Horizontal position of biaxial columns from the center to the right side, like the below figure? I'm Using Staad pro connect edition.

Hello, I am using Staad Pro Advanced Connect Edition. I am trying to analyse a plate with multiple holes. To accomplish this task I am using the structure wizard module for polygonal plate with holes under surface or plate models. I have successfully…

I am trying to model a Elevated steel water tank with bracing for analysis in STAAD.Pro. While modelling the structure I've encountered a problem and would like your help. The problem is: While the beam offset works perfectly for modelling a beam…

Dear All, I am new member of the forum and am looking for some answers in regards to one of my Staad Pro models. Greatly appreciate some information from you all experienced engineers. Can we super-postion two models in Staad Pro? I have 1…