Wall #6 is not supported along length and Columns have zero or negative height
Hello all,
In RAM SS, I am modeling an elevator pit for a multistory steel framed building. I have two levels for the elevator pit since the actual pit slab ("dummy slab") will be 6 ft below grade, and the walls continue another 11.5 ft down the dummy…
Is there a way to apply nodal loads at an angle in the Frame Elevation of the modeler?
Trying to apply nodal loads to a frame that is skewed and it seems the options are limited to X and Y only. Applying with X and Y components at frame end did not produce expected results.
Design of Solid slab (Conventional slabs)
Hello Everyone
For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…
Imposed Loads in RAM Modeler - Drawing Walls
Hi there,
When I export the floor to RAM modeler if I have a super imposed load not over the column grid I need to put in the loading using coordinates. As shown below:
If I need to change this slab. I then need to re-export it and then put in…