STAAD SPACE START JOB INFORMATION ENGINEER DATE 19-Nov-22 END JOB INFORMATION INPUT WIDTH 79 UNIT MMS KN JOINT COORDINATES 12 14700 6850 0; 13 19450 6850 0; 14 27450 6850 0; 15 30101 6850 0; 16 14700 6850 4200; 17 19450 6850 4200; 18 27450 6850 4200;…

How to give the design parameter of Lx(lateral torsional buckling) For column member. In my case, The column height is 12m, Minor axis direction tied at each 3m. But major axis direction not tied. What is the Lx parameter value?

See the attached image. I am wondering if there is a way I can use one large plate to connect all of the braces and the beam to the column, using bolts into the large gusset that is shop welded to the column. Can I replicate this in RAM? if so, how? Thanks…

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

How do I change Mton/Cm to Kn/m

Good Day, I would like to pose a question relating to the comparison between the RAM suite of software and those included with STAAD. Traditionally, my firm has used STAAD to complete all our structural analysis and design, however, considering as the…

T-beam bridge is a monolithic structure of slab and girders. Is Creating deck and beams separately gives good results ? how to model the above section?

warehouse.zip wind calculation also in that folder.... try to fix this probem guys

Buenas tardes compañeros, tengo una duda, utilizo staad.pro, para diseño de naves industriales, entrepisos, torres para tanques elevados, al igual que construcciones en concreto armado y todo con su respectiva zapata aislada o combinada, con análisis…

I have a problem in my project. I use ram connection in staad pro V8 and designed baseplate and pedestal. the design status is ok my problem is why does the design check is blank on the results?please help ASAP.

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?

Actually i need all members UC Ratio values. How to get all values???? Please guys guide me New folder (2).rar