Dear All, It has been so long since I first asked this question with no answer. Is there any way to delete existing load cases in openstaad or at least clear STAAD editor? because every time I do the analysis, loads repeat instead of replacing the previous…

Hi there, I'm modelling a steel frame in STAAD and looking to include c channel girts in the model. The girts (red lines) are to be located on the front face of the column with wall panels (green line) attached as shown below. I plan on using meshed…

Hi, I am modelling a steel frame and I have a sloped low roof made of steel deck and beams. I want to apply loading on the deck to be distributed to the supporting beams and also account for the lateral stiffness due to the deck. How can I do this?…

Hi all, is there a way to apply concentrated member loads as shown in the image below using STAAD? This is a plan view of a cylinder, the blue marks show each beam division and each beam is 1m deep by 0.5m wide. Please advise. Thanks.