STAAD SPACE START JOB INFORMATION ENGINEER DATE 19-Nov-22 END JOB INFORMATION INPUT WIDTH 79 UNIT MMS KN JOINT COORDINATES 12 14700 6850 0; 13 19450 6850 0; 14 27450 6850 0; 15 30101 6850 0; 16 14700 6850 4200; 17 19450 6850 4200; 18 27450 6850 4200;…

In STAAD Pro SS6 edition (Version 20.07.11.70) when a member subjected to Combined Axial force and bending, the member fails with higher ratios (i.e., 200, 216584 etc. ) according to section 9.3.1.1 as per IS 800 - 2007 (LSD). But when I calculate manually…

Hi, I was doing a case study for the combined beam & plate effect in STAAD Pro using AISC ASD. 2 geometries were prepared; 1. A simply supported beam subjected to 1kN/m UDL 2.A simply supported beam with plate structure bottom vertically restrained…

PEB.RESPONSE SPECTRUM ANALYSIS.std

I am trying to model a Elevated steel water tank with bracing for analysis in STAAD.Pro. While modelling the structure I've encountered a problem and would like your help. The problem is: While the beam offset works perfectly for modelling a beam…

I have designed a steel structures in staad pro. I have some doubts in below 1. I'm getting an error in member designed failed, how to resolve it. 2. In output, Some of my members gets failed and some gets pass how to resolve it and how to optimize…

warehouse.zip wind calculation also in that folder.... try to fix this probem guys

Is there any option to get report for the tension & compression flange stress ratio of built-up I-section for the critical load cases.

Hello everyone, I have a question about the bi-axial bending and torsion calculations in StaadPro based on EC3. I designed a beam (RHS) subjected to bi-axial bending and torsion. I am comparing my hand calculations with Staad pro unity check but…

Hi everyone! I am analysing a Channel section according to Eurocode 3 and I am finding it hard to understand how Staad calculates the critical Moment (Mcr) The critical moment I get from the program is different from the one I get from "Annex F of…

Hi everyone! Where can I find the expression for the parameters "FCZ", "FTZ", "FCY", and "FTY" in AISC ASD regulation? Thanks!

When running the STAAD, the result shows everything is right,. Structure is stable, no warning. Displacements are limited. BUT, I get some funny numbers for rotational displacement e.g. 533 degree & sometimes more. I checked releases. I believe they…

Hi I am performing a code check against EC3 and have specified the TRACK parameter as 2.0 i.e. to output detailed results. I see these results in the output file but there does not seem to be any way to include them in a report. If I select Steel Design…

I was wondering if there is any literature on the best way to approach the design of a simple four sided moment frame building using RAM Structural System? Thanks, Scott

Hai friends Please help us to solve problem with STAAD section informations. Staad developers kindly advice us. All query mentioned in the attached word file Thanks for ur support in advance Regards Bagmass

Section 5.20.3 states that "f 1 (Depth of section at start node) should always be greater than f 3 (Depth of section at end node)." In the model I am working in, it makes more sense for me to define my members from left to right which results in some…