STAAD SPACE START JOB INFORMATION ENGINEER DATE 05-Dec-22 END JOB INFORMATION INPUT WIDTH 79 UNIT METER KN JOINT COORDINATES 1 0 0 0; 2 10 0 0; 3 0 5 0; 4 10 5 0; 5 0 0 10; 6 10 0 10; 7 0 5 10; 8 10 5 10; 9 1.66667 5 0; 10 3.33333 5 0; 11 5 5 0; 12 6…

I am attempting to assign and design gusset plate connections using Ram connection using data from a RSS model. When trying to assign a connection detail to a joint the error The joint composed by node "171" and members "120, 886" is not valid "Column…

I receive an error message "Polygon intersection algorithm failed for the following input polygons:...." when I open RAM Frame. Once I click "OK", the RAM Frame module closes. I don't understand why I'm receiving this error. The only change I made in…

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

Hello, I received this message when I went to import my RAM Frame analysis to RAM Connection. I noticed that my load combinations did not appear in RAM Connection, and I was puzzled why. I found that I could generate my loads, but my base plate design…

I am analysing an RCC box girder for which some peculiar tapered sections have to be created. I created a tapered rectangular section in AutoCAD 2014. I used polyline to create the 2D and then extruded it to make it a solid 3D section. Now when I import…

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?

I'm modeling a 3 stringer short span timber bridge in staad. The model consists of the three beams and deck planks (which are modeled as Plates). All geometry, material properties, supporting, and loading have been assigned. There is only one error in…

I'm modeling a 3 stringer short span timber bridge in staad. The model consists of the three beams and deck planks (which are modeled as Plates). All geometry, material properties, supporting, and loading have been assigned. There is only one error in…

Hi, I am currently working on a project where I wish to use STAAD Pro v8i SS4 to perform a modal analysis to determine the natural frequency of a turbine exhaust extension. This is essentially a vertically orientated, stainless steel tube with intermediate…

Gents, today i'm working on pipe/tubular section in my model. to check the ratio in analysis, i'm using API code, but for non tubular section, i use AISC 9th Ed. however, i have some question regarding API code. (i use STAAD Pro v8i SELECT 4 20…

While trying to design a model which is all steel members, the following error pops up; SteelCollection.dll not registered. I have included a snipping of the error window. Any help would be great. Regards, Scott