Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?

Gents, today i'm working on pipe/tubular section in my model. to check the ratio in analysis, i'm using API code, but for non tubular section, i use AISC 9th Ed. however, i have some question regarding API code. (i use STAAD Pro v8i SELECT 4 20…

Hello to all, In reality horizontal braces (or vertical brace, beam, etc) that is design for tension only resist "some" axial compression capacity. Is there a way that this axial compression capacity can be input in STAAD? For example, a horizontal…

Hi, I am currently working on a project where I wish to use STAAD Pro v8i SS4 to perform a modal analysis to determine the natural frequency of a turbine exhaust extension. This is essentially a vertically orientated, stainless steel tube with intermediate…