Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

Dears, Concerning the design of RC beams in a PT slab, i am trying to determine the most accurate way to design the beams (determining top and bottom reinforcement). in Ram concept all design procedure is based on design section analysis. i prefer designing…

I have got my report, but there is no loading details like dead load, Wind loads and all... In report settings i have added Loadings, but its not showing.... Wt to do???? i want to see other load details. How to get that details?

First of all, I would like to let you know the objective of the subject is not pipe stress analysis result (as in other pipeline/piping software). I would like to ask for structural analysis related to pipe (pipeline) located in boxculvert. I need an…

I have set up a model in RAM. It is A steel frame sat on an RC base. I have run the data check and there are no errors or warnings. I have run the steel beam design and it has given me section sizes. However, every time I try to run the steel…