• Tension Members Only and Track 2

    Mallory Harvey
    Mallory Harvey
    I know it has been asked but I cannot seem to get my file to bypass the slenderness check for the tension only bracing members. My file is attached if someone knows what i am doing wrong? I also do not believe it is printing out the full design track…
    • Answered
    • over 1 year ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • STAAD not basing slenderness calculation on LY parameter

    Patrick Wanamaker
    Patrick Wanamaker
    I've got a situation where I am assigning LY = 5' to some C6x13 (ry = 0.524") girts of varying lengths that will have restraint from sag rods spaced around 5'. However, when running the code check (AISC Unified 2016), my girts continue to fail from Cl…
    • over 2 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • Slenderness Ratio

    Ramesh Khatiwada
    Ramesh Khatiwada
    It is very weird. I just did the below cable tray support design. Both the members highlighted below are same length and have same load. The top member fails due to slenderness but the bottom is okay. Has anyone ever come across the similar situation…
    • over 4 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • View related content throughout RAM | STAAD | ADINA
  • More
  • Cancel