Dear All, It has been so long since I first asked this question with no answer. Is there any way to delete existing load cases in openstaad or at least clear STAAD editor? because every time I do the analysis, loads repeat instead of replacing the previous…

Can I use the change command to change the design parameters? It takes the last assigned parameters all the time.

I'm Designing a Two-way solid slab (Slab on beams) from Staad pro to RCDC. What is the Imposed Load of RCDC? Does it mean the self-weight of a slab or Floor Finishing load?

Hello Everyone Which is better to intersect the primary beam and secondary beam (Figure1), or Merge the primary beam to be one (Figure2)?

Hello Everyone For a while, I was using an Advanced Concrete Design (RCDC) for the design of a solid slab. Today I tried to learn the RAM concept for the slab designs but I saw a design of strips that had never seen before (When I was using RCDC and…

Hello Everyone. I create a dummy beam with density=0 and E=0 (Figure.1) then I assign the beam (Figure.2) then Staad Error occurs( ***ERROR*** MATERIAL NAME MUST NOT CONTAIN ANY BLANK SPACE )(Figure.3), What is the solution?

How to create a cantilever slab without beams in the Physical modeler in STAAD connect edition?