• objOpenSTAAD.Property.AssignBeamProperty Error

    Anna Moss
    Anna Moss
    Hello all, I'm trying to assign material to the beams in STAAD through VBA using the OpenSTAAD library. However, when I try to assign the material to the beam through objOpenSTAAD.Property.AssignBeamProperty 7, 1 I get the a Run Time error in Excel…
    • Answered
    • over 6 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • OpenSTAAD | GetBeamList command is not working

    Denisson Cruz
    Denisson Cruz
    Greetings STAAD fans, I am developing a VBA to the get the list of beams and after a couple of tries I have notice that the OpenSTAAD | GetBeamList command is not working. Any suggestions? See the following VBA Macro Sub GetBeamList() On Error…
    • over 6 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • Cannot open STAAD from Excel VBA Openstaad- Create Object - Regd

    CVP CVP
    CVP CVP
    Dear All, I have done some coding using Excel OPENSTAAD. I used Set objOpenSTAAD = CreateObject("StaadPro.OpenSTAAD"). Usually when i execute the command, STAAD opens up by itself runs the analysis. But all of sudden im getting run time 429 error…
    • over 7 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • RE: PLATE SELECTION VIA OPEN STAAD

    Sudip Narayan Choudhury
    Sudip Narayan Choudhury
    Sekecting Plates.xlsm You are right. Prima facie, "View.SelectGroup" function does not appear to be working the way it should. We will check this further. Also, please find below a macro in selecting a group of plates which uses the Geometry.SelectMultiplePlates…
    • over 7 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • Query regarding openstaad and VBA

    Saurabh Shah
    Saurabh Shah
    I have made a vb program (listed below), it runs well inside object browser, but when i run it from usertools (i.e assigning it to the usertools) it shows error. error: 10092 Activex automation, cannot create object. code: Sub Main() Dim oStd…
    • over 10 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • Openstaad member end forces not matching postprocessing numbers

    Eric Anderson
    Eric Anderson
    I have a staad model I built programmically. The file opens and performs a successful analysis from within STAAD but when I try to pull member end forces from a c# program I'm developing the forces are different? I also modifed one of the simple openstaad…
    • over 14 years ago
    • RAM | STAAD | ADINA
    • RAM | STAAD Forum
  • View related content throughout RAM | STAAD | ADINA
  • More
  • Cancel
<