Hello everyone
My name is Sara from Italy, I am very new to the Sacs, could you please help me
First of all; after assigning all the member sections in order to perform static analysis, shall I calculate all the section's self-weight by myself and…
Hello,
I currently working on my undergraduate final project which is simulation to jacket and topside transportation, I used the vessel from Ultramarine library (brg300) to generate transportation the jacket. So, far I tried to insert model jacket…
Body X Y Z RX RY RZ -------- --------- --------- --------- --------- --------- --------- HOLMEN_P Location -0.00 0.00 -5.24 0.95 0.55 -0.00 N Force -124.47 -192.61 -0.01 31 0 -17523 Equilibrium Converged in 5 Iterations Time To Generate Load Cases : CP…
I don't think I understand what you are trying to analyze. It sounds like you are asking if you can perform an analysis of the pile using inertial loading from transportation. This can be accomplished using the tow analysis where you can model the pile…
Dear Sir,
I have short question. Can we perform 'Frequency Domain Transportation in SACS' ??
The assumption is
1) We have Barge RAO
2) We know critical seastate i.e. wave spectrum, Hs, Tp
The following queries is needed some guidance.…
Hello! I am analyzing a Jack Up Rig with a single column for wet tow. During wet tow, the jack-up will be floating on its hull and the column will be above water.
The procedure I have adopted is as follows:
1. Perform a wave dynamic analysis in SACS…
I am curious about RAO command in SACS Tow input file.
See attached picture, I put RAO = 1g (m/s^2 /m) which is already base on unit wave amplitude (Wave height / 2).
Unit wave amplitude is 1m. (Wave Height = 2*1m = 2m)
Then, SACS should give…