• Cylinder End Representation

    William Marshall
    William Marshall
    Hi I'm new user of open building. I am having a issue with a simple cylinder. As you will see in sketch below, there is a blue and red cylinder end. The blue one was drawn randomly and then in it's properties the end points on either side were modified…
    • over 1 year ago
    • OpenBuildings | AECOsim | Speedikon
    • OpenBuildings | AECOsim | Speedikon | Forum
  • Triangle orientation based on Height

    William Marshall
    William Marshall
    I have created a triangle with some parametric constraints. I have also created some Variables to calculate the angle (X). When (C) is at a higher point to (A-B), (X) will be a positive value. I have no issues adjusting for triangle ABC by inputting Lengths…
    • over 1 year ago
    • OpenBuildings | AECOsim | Speedikon
    • OpenBuildings | AECOsim | Speedikon | Forum
  • How to control scale of a geometry map for material?

    Rafal Razmus
    Rafal Razmus
    I created a custom material and used one of the pattern cells as a geometry map. The problem is when I create a clip volume this pattern is not displayed in 1:1 ratio, like Y scale is different to X scale. On the picture below the red wall is generated…
    • over 1 year ago
    • OpenBuildings | AECOsim | Speedikon
    • OpenBuildings | AECOsim | Speedikon | Forum
  • View related content throughout OpenBuildings | AECOsim | Speedikon
  • More
  • Cancel