Hello community,
When I try to install the OpenBuildingsDesigner_x64.10.09.00.083, I get the following message (attached image).
How could I solve it?
Thanks in advance.
I am currently working through some Bentley OpenBuildings Designer learning paths. But sometimes I am coming across training videos that doesnt tell you where to find the training files or models from.
Is there a central location where these are all…
Hello,
I am trying to find a way, similar to Revit, where I can show wall types in different colour. In Revit, a WALL FILTER is added with an override.
The above image shows what I am trying to achieve you can see that different colour has been…
Save the date - on September 29th my dear colleague Meenakshi Sharma will host the next #OpenBuildings Designer Live Session #4 - Freedom For #Design Anything. Let her and Katarzyna Włosowicz get you on a fast track to unleash the potential of #BIM in…
i want to create a dynamic view using the front/cut and back
the reason for this:
Front cut just below the ceiling,
the cut, difine the cut in a heavier line weight (or stronger colour)
Back all set to broken line (st=2)
the only problem is…
Hello,
I am working on a project utilising OpenBuildings (Update 6). The electrical engineer on the project has modelled conduit using Revit and I am attempting to utilise this to produce electrical layout drawings.
I downloaded the Bentley plugin…
This is just a general question if OpenBuildings has this capability: can you create fire hydrants, water lines and power lines a part of a Building Site in OpenBuildings?
I'm a new user to OpenBuildings and the project that I am working on is all done…
Hi All
Within a call-out structural columns show just as centre lines, if the view is demoted the columns display correctly, however any hatching will disappear
Promoted View
Demoted View
Using OBD 5
Any suggestions
Cheers
Chris
I have a cyan cable trough "flying" above the white concrete. I need it to be moved down and follow the surface of the concrete.
Q1: Is there any alternative solution to achieve this? I have used move + rotate to move the cyan trough to red trough location…