I would like to analyze a steel stringer bridge that has a transverse nail laminated wood deck. Am I able to import this wood into the Material Library in any way?

I would like to use CSA S6:19 as the design spec for my steel bridge design in LEAP Bridge Steel. Am I able to do this? I would prefer to use SCA S6:19 over AASHTO spec.

I am pretty new to using Leap Bridge Steel, and have a question regarding a project I am working on. I have attached a general framing plan, and was wondering if Leap Bridge Steel was capable of modeling it, mainly due to the partial length girders. The…

In Leap Bridge Steel, I have a curved bridge, so the girder lengths are not integer values. Under the Member Definition tab I'm unable to manually input flange plate lengths to a sufficient decimal in order to be able to run analysis (see below for the…

Hi, In the article below it mentions that the issue where "Distance from top of concrete deck to the neutral axis of the composite section at the plastic moment was incorrectly calculated." is fixed. However, I'm still running into this problem when…

Has anyone else seen this error? I am trying to link an OBM model to LEAP Bridge Steel for the first time. Any guidance on where to start looking would be helpful. Thanks, Justin