Hello all, I currently have a bridge with 3 spans in OBD. In span 1 and 3 I'm using concrete girders while in span 2 I'm using built up steel girders. I will be using LEAP Steel to design the steel girders and Leap concrete for concrete girders. My question…

I am pretty new to using Leap Bridge Steel, and have a question regarding a project I am working on. I have attached a general framing plan, and was wondering if Leap Bridge Steel was capable of modeling it, mainly due to the partial length girders. The…

When I transfer from OBM to LEAP Steel, the field splice display is not showing properly. Usually the display shows like the picture below with the plates and bolts. Instead it is showing up with nothing. I'm assuming it is just a glitch from…

Hi, When I send my physical model from OBM to LEAP Bridge Steel, I am getting following error message. "File Path is not valid". Please advise how to resolve this issue.

Hi All, I'm calculating the screed elevations, top of haunch elevations, and final deck surface elevations. I had the following questions: Is there a way to get OpenBridge Modeler or LEAP Bridge Steel to provide these elevations? Or is the best…

My colleagues and I have started recording videos and posting them to your YouTube page in the last few weeks. These 1-5 minute clips are there to assist you with day to day use of the various Bentley Bridge solutions. The CONNECT Advisor will assist…