Can I analyze a Wooden Deck Steel Bridge with LEAP Steel?
I would like to analyze a steel stringer bridge that has a transverse nail laminated wood deck. Am I able to import this wood into the Material Library in any way?
Open Bridge Designer Leap Bridge Steel - Partial Length Girders
I am pretty new to using Leap Bridge Steel, and have a question regarding a project I am working on. I have attached a general framing plan, and was wondering if Leap Bridge Steel was capable of modeling it, mainly due to the partial length girders. The…
LEAP Steel Bridge - Field Splice Analysis not running
The bridge I am working on has 4 splice locations at each member. For some reason, after running an analysis, the first and last field splice do not appear to be updated and the program is still prompting me to run an analysis at those locations before…
LEAP Bridge Steel version 22.00.02.19 - decimal requirement issues
In Leap Bridge Steel, I have a curved bridge, so the girder lengths are not integer values. Under the Member Definition tab I'm unable to manually input flange plate lengths to a sufficient decimal in order to be able to run analysis (see below for the…
LEAP Steel Under Design Summary Report doesn't flag failing members
Has anyone else had this issue? I can run an analysis and nothing gets flagged in the "Under Design Report", but after looking at the Strength V Limit State reports there are failing members in Shear. Also I have attached an example picture of what the…
Calculating PNA of curved tub-girders for Eq. 6.10.7.3-1 in LEAP Bridge Steel version 22.00.02.19
Hi,
In the article below it mentions that the issue where "Distance from top of concrete deck to the neutral axis of the composite section at the plastic moment was incorrectly calculated." is fixed. However, I'm still running into this problem when…
Kinked and flared continuous steel girder
I need some advice.
Situation
I have a flared steel bridge. the bridge is continuous. i am using leap steel bridge. there are 6 girders.
basically girder spacing at abutment 1 is 14 ft +/- and pier 2 is 13 ft +/-. (Flare portion).
From Pier 2…
Leap Steel Influence Lines
How do you get Leap Steel to print influence lines for a specific point on the bridge?
OBM + LEAP Steel - Deck Elevations
Hi All,
I'm calculating the screed elevations, top of haunch elevations, and final deck surface elevations. I had the following questions:
Is there a way to get OpenBridge Modeler or LEAP Bridge Steel to provide these elevations? Or is the best…
Leap Bridge Concrete Video Problem?
Has anyone seen this issue in lasted version of LEAP
End user has new Lenovo P52 laptop and all drivers up to date. When rotating object you get a fan image around object as shown in screenshot.
We have another user with same P52 laptop and drivers…