Hi If we define bar length, is leap bridge software have capability to deduct development length based on dia of bar and calculate flexure check at that point.

I am pretty new to using Leap Bridge Steel, and have a question regarding a project I am working on. I have attached a general framing plan, and was wondering if Leap Bridge Steel was capable of modeling it, mainly due to the partial length girders. The…

The bridge I am working on has 4 splice locations at each member. For some reason, after running an analysis, the first and last field splice do not appear to be updated and the program is still prompting me to run an analysis at those locations before…

In Leap Bridge Steel, I have a curved bridge, so the girder lengths are not integer values. Under the Member Definition tab I'm unable to manually input flange plate lengths to a sufficient decimal in order to be able to run analysis (see below for the…

Hi, In the article below it mentions that the issue where "Distance from top of concrete deck to the neutral axis of the composite section at the plastic moment was incorrectly calculated." is fixed. However, I'm still running into this problem when…

Does RC Pier check shear friction in the pier cap (AASHTO 5.7.4)? I've looked in the output reports and didn't see reference to this spec section. I've also looked in the application help interface and couldn't find it. Note: my application version…

Title: SIG Virtual Workshop: OpenBridge – Workspace Configuration in OpenBridge Designer Presenter: Steve Willoughby, Senior Application Engineer, Bentley Systems, Inc. Date/Time: June 11, 2020 2:00 P.M. EDT Register Now This OpenBridge…

OpenBridge Special Interest Group: Using a BIM or Standalone Workflow in OpenBridge Designer Host: Alex Mabrich, Senior Application Engineer, Bentley Systems, Inc. Date/Time: April 7, 2020 at 2 p.m. EDT Register Now This OpenBridge…