In Leap Bridge Steel, I have a curved bridge, so the girder lengths are not integer values. Under the Member Definition tab I'm unable to manually input flange plate lengths to a sufficient decimal in order to be able to run analysis (see below for the…

Hi, In the article below it mentions that the issue where "Distance from top of concrete deck to the neutral axis of the composite section at the plastic moment was incorrectly calculated." is fixed. However, I'm still running into this problem when…

I need some advice. Situation I have a flared steel bridge. the bridge is continuous. i am using leap steel bridge. there are 6 girders. basically girder spacing at abutment 1 is 14 ft +/- and pier 2 is 13 ft +/-. (Flare portion). From Pier 2…

When I transfer from OBM to LEAP Steel, the field splice display is not showing properly. Usually the display shows like the picture below with the plates and bolts. Instead it is showing up with nothing. I'm assuming it is just a glitch from…

Hi All, I'm calculating the screed elevations, top of haunch elevations, and final deck surface elevations. I had the following questions: Is there a way to get OpenBridge Modeler or LEAP Bridge Steel to provide these elevations? Or is the best…