I need to vary the width of the top flange of a Super-T girder (Australian) to follow the curved edge of a bridge deck. I can add variables to the points on the beam template but can't see how to access them/set them when the beam is used in a beam group…

Hi all. I have a question about Reinf crack for prestressed concrete as follows: If you calculator stress bot of section beam in MinMz_Service exceeding allowable stress tension limit is 0,5 x sqrt(f'c), you can calculator reinf area to control crack…

Hello, Camber and deflections are reported at 10th points along the beam. I am modelling a longer span which will require more than 10 screed points. Is there a way to toggle the number of points? Or do I have to interpolate? Thanks,