• Running 2 pumps in parallel

    Nuey Tucker
    Nuey Tucker
    Good Morning Everyone, I am a bit new to WaterCAD. I am trying to model 2 lift station pumps with different curves running parallel and joining together before tie in into a Force main. The model is attached. I am not sure how much data to input…
    • Answered
    • over 2 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • Hands on Training Program on Water Distribution Design & Modeling by Bentley WaterCAD / WaterGEMS by Industrial Expert

    Sameer Latkar
    Sameer Latkar
    Hands on Training Program on Water Distribution Design & Modeling by Bentley WaterCAD / WaterGEMS by Industrial Expert Location: IFS Academy, Pune, Maharashtra, India. Course Description This class begins with the basics of hydraulics…
    • over 5 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • Bentley SewerCAD, StormCAD and WaterCAD model to Civil 3D

    Colm Kelliher
    Colm Kelliher
    Hi, Is it possible to export a StormCAD model to Civil 3D with all the pipe sizes and characteristics etc. Thanks, Colm.
    • over 8 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • WaterCAD - concentration logic?

    Eugene Williams
    Eugene Williams
    I have a particular scenario that has been created for TTHM modeling in an existing system. Care has been exerted to model as close to field data as possible. Field data was used for initial amount at sole water source and modeled to conform to data extracted…
    • over 14 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • View related content throughout OpenFlows | Water Infrastructure
  • More
  • Cancel