• Low pressure and high velocity

    Ragavendra V
    Ragavendra V
    Hi, I am a doing modelling for improvement of the existing system. Many location velocities are high and pressure is low. Even I tried to increase the pump capacity the pressure is not increased. Please check the model in the below following link…
    • over 3 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • No Flow in tank Top inlet fill

    Ragavendra V
    Ragavendra V
    Hi, I have another issue in the model, If you check the T-1 inlet it was connected as a top inlet. When I run the simulation for avg daily demand I don't have any issue. However, when I run the same model with Max daily demand scenario (Peak factor…
    • Answered
    • over 3 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • watergem failed to validate model. the model may be corrupt or contain incomplete information

    Ragavendra V
    Ragavendra V
    Hi, I have an issue validating this water gem file. Even I am using the latest version of water gem update 210.02.01.06 64-bit it is still showing the same error. Please let me know how to fix this error. I have uploaded the file in the below wetransfer…
    • Answered
    • over 3 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • isolation valve position

    mohamed tablia
    mohamed tablia
    Hello, How could I locate an isolation valve at a specific position on a pipe with a schematic drawing? Can an isolation valve replaced by another type of valves in watergems to do the same task?
    • Answered
    • over 4 years ago
    • OpenFlows | Water Infrastructure
    • OpenFlows | Water Infrastructure Forum
  • View related content throughout OpenFlows | Water Infrastructure
  • More
  • Cancel