Heating Pipe Sizing in Netsys - Emitter Queries
Hi,
Its been a while since the last time I used Hevacomp so apologies if the questions seem trivial.
I am trying to model a relatively large project, I have already placed all my emitters (some ceiling void, some floor level).
When I try to connect…
Hevacomp to openbuilding designer. Heating, gas, Hot and cold pipework design.
As i understand. Bentley Hevacomp is being retired and replaced with openbuilding designer.
I cannot find any training for openbuilding designer to do with plumbing systems. Only ductwork ventilation systems.
I would like to know how to design a heating…
New Pipework type for Netsys, Heating
Hi,
Is it possible to have a new pipework type on NETSYS, heating? I need to use the attached details below for the modelling. Please refer to the attached file for reference.
PDF
Please, if you have other resources that you use with this type…
Could you please provide details on how Hevacomp calculates system contents on both cooling and heating systems ?
I would like a break down of what hevacomp uses for calculating system water contents on heating and cooling systems.
RE: de-active snap grid
Hi Arun, you can change this setting by going to Pipes > Defaults, and deselecting the Snap Grid option. Also, if you wish to change the Ortho settings you can do so by going to Defaults>Ortho.
You can see this operation if you view this document .