The standard report template in RailTrack shows cant-grediance as "transition length / cant". I need to report the value "cant / transition length" (in promille). The xsl-syntax for reporting gradient is "<xsl:value-of select="inr:distanceFormat(number…

How do i do this? I have to replace wooden sleepers over a bridge and I have survey points on both left and right side of each sleeper set out on the bridge deck (see attached drawing). I need to know the distance between the bridge deck level…

Dear Friends, Please tell me, How we can calculate the Cant deficiency & Cant excess of a particular curve. For example, radius of curve is 200m and cant provided is 110mm for 55 kmph speed. tell me how we can calculate Cant deficiency & Cant excess…

Dear All, I am facing a problem with rail elevation this is most importent for me to show rail elevation in the profile, our railways did'nt accept with out rail elevations, for rail elevation again i am going to auto cad. I am creating a horizontal…

Hi I'm designing af very complicated transition area where several of the turnouts are placed in curves with cant. I use Create Vertical function to design the vertical of the second alignment in the turnout. When I draw out the 3D alignment…

Hi, I just wanted to check the point controls that the Roadway Designer uses for Cant. The Cant Center Point is on the Centerline but should you place the Left and Right points at the centre of rail or the gauge of the rail lines. I'm assuming…

Hi, I have a problem with the LandXML translator. When I try to export alignments to LandXML 1.1 from InRail XM (8.9), InRail crashes. It works when I don't have any cant alignments, but as soon as I have a non-empty cant alignment, InRail crashes…

Hi Friends I have a question about designing turnouts on an spiral / transition curve with cant applied. We have a case where we need to replace 2 turnouts and a connection, with 2 new turnouts and a connection. We can't move the turnouts location…

my alignment has 4 curves and i have applied cant as follows 1-curve (RH)-----+ve cant 2-curve(LH)------ -ve cant (Cant direction same as on curve 1 but because curve direction is different from previous on so in BRT i input it as -ve cant) 3…

Does anyone have a sample of a Station, Speed and Cant Table? The help file only sates the following ... Station, Speed and Cant Table specifies the applied cant and design speed are defined in a file. The format of the file is station, design…

Dear everyone I need to export my alignment including horizontal, vertical and cant to a LandXml file - but my Cant does not export. Or maybe it doesn't import. Could someone show tell which box to click on when exporting and importing? I…

Hi, I'm InRoads user but getting started with BRT. I have problems with cant applied to dual track template. My workflow: 1. HA and VA design for RightTrackCL. Using Parallel Horizontal Alignment command I created HA - LeftTrackCL. 2. Cant design for…

I have placed a cell for the tie in the cross sections that includes cant in the curves. My ballast section is a part of my template. Is there a way to make the ballast section match the tie in the sections where cant is applied?

Guys, I need your help again. I'm trying to get my second track to follow the cant I've edited for the alignment, but it just seems to set itself to zero elevation instead of following the first track's vertical elevation. My templates have the…

Hi, I have created a template and a roadway design but when I put the point controls on for the second track the points I have placed for the second set of rails are not moving with the second alignment. I have used a horizontal point control…

Hi, I am having trouble with MX Rail: Cant Table as it decides to change my Design Speed when I Apply, is there an alternative method for Applying Cant or manually adding values such as E,D, RoCC, CG, Jerk etc. Thanks ~CL