• How to add bored cap to a SPEC

    P Manoj Kumar
    P Manoj Kumar
    How to add bored cap to a SPEC (Eg DN330XDN25 size) in Open Plant connect Edition. The problem is bored cap will have main port and run port as in case of reducer. A a drain line will connected to the run port of the cap. Normally it is placed in reducer…
    • over 2 years ago
    • OpenPlant | AutoPLANT
    • OpenPlant | AutoPLANT Forum
  • Bentley SpecGen - Specification Generator - Slow loading on Rebuild

    YPS-TheGoodFight
    YPS-TheGoodFight
    Hello,I use Bentley Specification Generator V8i (SELECT series 3) or SpecGen for short. In the SpecGen program. I copied a template Spec in my Project. In the Spec itself; I edited the tables to filter down the 1000's of parts etc to match this projects…
    • over 9 years ago
    • OpenPlant | AutoPLANT
    • OpenPlant | AutoPLANT Forum
  • PlantSpace Design Series - Place Piping by Spec or Cat

    HulStud
    HulStud
    All, I appologize if this is somewhere else but i looked and can not find anything. I have recently been charged with designing/drawing the piping for a new water treatment plant. Unfortunatly the gentleman that knew this stuff has left our firm, hence…
    • over 11 years ago
    • OpenPlant | AutoPLANT
    • OpenPlant | AutoPLANT Forum
  • Spec Gen Catalog for Anvil Pipe Supports

    Ben Fullenkamp
    Ben Fullenkamp
    Does anyone know of the existance of pipe supports for Anvil? There is not one included with Plant XM or 2004, but I didn;t know if there was one for v8i, or an alternate one out there that did not come with the software.
    • over 14 years ago
    • OpenPlant | AutoPLANT
    • OpenPlant | AutoPLANT Forum
  • AutoPLANT V8i (SELECTseries 3) "Refresh" Release ReadMe's...

    ChrisB
    ChrisB
    The ReadMe files for the recent AutoPLANT V8i (SELECTseries 3) "Refresh" Release are now available for download from the Files section of this forum. Thanks. Chris
    • over 11 years ago
    • OpenPlant | AutoPLANT
    • OpenPlant | AutoPLANT Forum
  • Enhancing Catalogs

    DPC
    DPC
    I would like to create components in V8i that are realistic representations of the actual components. I also have some some components that aren't 'out of the box' type components. Is this a realistic avenue to pursue? Can it be done in Bentley or am…
    • over 14 years ago
    • OpenPlant | AutoPLANT
    • OpenPlant | AutoPLANT Forum
  • View related content throughout OpenPlant | AutoPLANT
  • More
  • Cancel